Bottom Sash Side and Top beads

These need measuring to get the height of the bead. Rather then use a tape I assembled the bottom sash and clamped it up.

With a 5mm packer under the bottom of the BS Bb place the side beads on the sash.

Using the top bead as guide, mark where the mitre needs to go. All things being equal the other side should be exactly the same, so the mark can be transferred across.

Cut the mitres off on morticer and router off the excess( as previous step, and all the tooling should still be set up right).

Using the sides, mark up the width of BS Tb

These can then be cut using the the table saw.